SHIMANO NEXUS 3 SPEED HUB MANUAL INSTALL
SHIMANO NEXUS 3 SPEED HUB MANUAL DRIVER

9ДЎ0 2 GREASE SET SET 04 PE-LD Exploded view and parts list 17 SHIMANO NEXUS 3-SPEED HUB w/hi-power Roller Brake SG-3R40 Inter-3 Hub BR-IM31-R Inter-M Brake For Axle Length mm MIN.2Nm JAPAN Internal Assembly Grease For Axle Length mm / mm For Axle Length mm For Axle Length mm / mm Bell Crank lll ITEM NO PART NO. This completes the assembly of the Inter-3 hub. Push right hand dust cap A firmly onto the hub shell until it clicks. Apply a coating of internal hub grease to the inside of right hand dust cap A to waterproof it. If the hub shell does not turn smoothly, re-install right hand dust cap A. Right hand dust cap A Check: After installing right hand dust cap A to the hub shell, turn the hub shell clockwise and check that it turns smoothly.

SHIMANO NEXUS 3 SPEED HUB MANUAL INSTALL

Install right hand dust cap A to the hub shell.

SHIMANO NEXUS 3 SPEED HUB MANUAL DRIVER

Driver Vice Do not damage the threads of the hub axle. Turn the hub upside down and hold the two bevelled surfaces of the axle in a vice. TL-HS10 (14 mm) Lock nut for left hand cone Tightening torque: N m TL-HS10 (14 mm) Left hand cone 12. After adjusting, secure the left hand cone with the lock nut for left hand cone. Screw on the left hand cone to adjust so that the hub shell can be turned smoothly without any play. While turning the hub shell counterclockwise slightly, place it onto the internal assembly. Then loosen the right hand lock nut and the right hand cone with dust seal to adjust until there is sufficient play. If there is no vertical play and the carrier unit turns stiffly, turn the internal assembly upside down and hold the hub axle in a vice. Stop ring (9.6 mm dia.) After inserting the stop ring, check that there is a small amount of play in the carrier unit in the vertical direction. Insert the stop ring into the groove of the hub axle.

Teeth of carrier unit planetary gear Teeth of ring gear unit Check: Check that the stop ring groove of the hub axle is visible from the edge of the carrier unit after the carrier unit has been installed. Apply a liberal coating of internal hub grease to the planetary gear (in 4 places) inside the carrier unit. Engage the teeth of the planetary gear of the carrier unit with the teeth of the ring gear unit while turning the carrier unit slightly to the left and right and pushing it onto the ring gear unit. Apply a liberal coating of internal hub grease to the gear inside the ring gear unit. Check that pawls A-1 and A-2 are engaged with the ratchet mechanism in the ring gear unit. Check that pawls B are not hooked onto the clutch. Apply a liberal coating of internal hub grease. Pawl A-1 Ring gear unit Pawl B Internal ratchet mechanism Pawl A-2 OK Driver unit Screwdriver Not OK Be careful of the directions of the two pawls B. While pushing the two pawls B on the ring gear unit with your fingers, push the two pawls A-1 and the two pawls A-2 on the driver unit one by one with a screwdriver and install the ring gear unit to the driver unit.

Shimano nexus 3 speed hub manual